All it takes is a flat-head mop with a microfiber cleaning pad and commercial wood floor polish, which comes in low- or high-gloss sheens to achieve your desired look. Whether or not you should polish your floors, however, depends on their finish. Those with a protective surface—a waterproof barrier such as urethane, for example—will benefit from polish, but floors with penetrating finishes like tung oil or unsealed wood require wax instead of polish.
Using the wrong product can cause a host of problems, from making floors too slick to dulling the finish, and impair proper refinishing down the road. Empty the room, removing as much furniture as possible, then clean the floor thoroughly to remove dust and dirt. Sweep or vacuum, then mop with a commercial wood floor cleaner or solution of a quarter-cup of dish soap and a gallon of warm water to lift any lingering grime. Give the floors a final pass with a clean, water-dampened mop to remove any cleaner residue.
Dry completely with a soft, clean towel. Begin in a back corner of the room, plotting a path that will have you end up near an exit, pour a small S-shaped amount of wood floor polish onto the floor. Using a flat-surface mop, work the solution back and forth in the direction of the wood grain, smoothing out any air bubbles.
While you must make sure to completely coat the floor, thin layers will dry more rapidly than thick ones, and you can always apply another coat if needed. A screening or buffing uses a fine grit of sandpaper only loosening up the top layer of the polyurethane. This is a great way to remove surface scratches and dirt from your floors. An application of polyurethane adds a coat of protection and sparkle back to your hardwood floors!
Buffing or screening will not address deep scratches, gouges, dents or stains on your hardwood floors. Once scratches or stains have have penetrated below the surface layer of the wood the floors will require a full sanding. The importance of cleaning products used on hardwood floors is underrated. There are so many products on the market now that it is no wonder consumers are confused. Basically any cleaning products with oil soap, wax or silicone will interfere with polyurethane adhering to the hardwood floors.
A full sanding is required to liven up hardwood floors when they are worn down and little to no finish remains or gray patches are evident. With major renovations and repairs often a full sanding is required. Some homeowners wish to change the flooring color in a room. Hardwood floors must be sanded in order to alter a flooring color.
How can I make my old hardwood floors look better? Make any necessary repairs. Clean the floor. Allow the floor to dry. Gently scuff the old finish. Vacuum the dust. Apply your chosen finish. Additional References for Refinishing Wood Floors. How do you naturally polish hardwood floors? Add in the hot water. And drops of lemon essential oil. If the floor is too slick after cleaning, use a cloth to wipe up any remaining oil.
How much does it cost to buff and polish wood floors? What takes scratches out of hardwood floors? Follow these steps to repair a minor scratch: Clean the surface. Use a quality wood cleaner to pick up any debris. Use steel wool on the scratch. Only rub the scratched area, and always rub with the grain of the wood.
Buff the scratch. Blend the edges. Use a wax stick. Buff the area. Use a paste wax. How do you cover up scratches on hardwood floors?
0コメント